AT&T U-verse 5031NV

From TechInfoDepot
Jump to: Navigation, search
File.JPG
Tagline Needed
3rd Party Firmware
dd-wrt
Status Unknown
OpenWrt
Status Unknown
Tomato
Status Unknown
TomatoUSB
Status Unknown
Gargoyle
Status Unknown
Platform
Brand Model Rev
AT&T U-verse 5031NV
FCCID
none specified
Type
unspecified
CPU1
brand? Model?
CPU1 Speed
?
Flash1 Chip
brand? Model?
Flash1 Size
? MB
RAM1 Size
? MB
RAM1 Chip
brand? Model?
ETH chip1
brand? Model?
Wired Standard
IEEE 802.3?
Ethernet interface OUI
none specified
Expansion IF types
none specified
Power
12 VDC, 3 A
Connector type
barrel
radio1
Chip1
brand? model?
Wireless interface OUI
none specified
Antenna Connector Type
none specified
Wireless Standard
IEEE 802.11b/g/n
WiFi Operating Frequency
2.4 GHz

Wikidevi Notes[edit]

Rebranded Pace 5031NV which is a rebranded 2Wire 5031NV?

Links of Interest[edit]

Flashing[edit]

Upgrading[edit]

Reverting[edit]

JTAG-Serial Info[edit]

USB Info[edit]

vlan Info[edit]

Pictures[edit]

Notes[edit]

Bridging[edit]

There is no true bridge mode on the 2Wire routers. However, you can still configure it such that almost all functions of your own router will work properly.

  1. Set your router's WAN interface to get an IP address via DHCP. This is required at first so that the modem recognizes your router.
  2. Go to Settings -> Firewall -> Advanced Configuration
  3. Uncheck the following: Stealth Mode, Block Ping, Strict UDP Session Control.
  4. Check everything under Outbound Protocol Control except NetBIOS.
  5. Uncheck NetBIOS under Inbound Protocol Control.
  6. Uncheck all the Attack Detection checkboxes (7 of them).
  7. Click Save.
  8. Plug your router's WAN interface to one of the 2Wire's LAN interfaces.
  9. Restart your router, let it get an IP address via DHCP.
  10. Log into the 2Wire router's interface. Go to Settings -> Firewall -> Applications, Pinholes, and DMZ
  11. Select your router under section (1).
  12. Click the DMZPlus button under section (2).
  13. Click the Save button.
  14. DO NOT reboot the modem as the settings will go all wonky and you will have to start over
  15. Reboot your router or renew the DHCP address, the Routers IP address should be your public IP

Hardware Modification[edit]

See Also[edit]